Sticks; Inserting The Battery; Charge The Battery; Low Voltage Warning - GRAUPNER MC-32EX Manual

Transmitter preparation

Sticks

As described under „Switching the control sticks" on page 16 in
the section „Back of the transmitter ", their neutralization, braking
force and ratcheting ratchet effect as well as their restoring force
must be customize to the pilot's habit.
Notes
• Due to the three-position switches integrated with both
sticks, the length of the sticks is NOT adjustable.
• Which of the two sticks is to be switched to non neutraliz-
ing also depends on the selection of the control mode, see
below under „Starting up the transmitter".

Inserting the battery

Note
When connecting the battery, make sure that the contact is
completed. Interruptions to the power supply to the transmit-
ter in model operation can become a serious hazard to your-
self and others.
See „Insert and connect the transmitter battery" on page 16 in
the "Transmitter back" section for more information.

Charge the battery

The transmitter battery is charged via USB C socket in front of the
transmitter under the flap of mc-32-logo. See „Charging the trans-
mitter battery" on page 19" in the "USB C Connection" section
for more information.

Low voltage warning

The supply voltage of the transmitter must be monitored during
operation. If the capacity fall below an adjustable limit, 20% of
default, a corresponding warning sounds continuously.
At this point, model operation must be stopped immediately and
the transmitter battery is to be charged or replaced!
Attention
As soon as the supply voltage of the transmitter fall below
3.6 V, the transmitter switches off automatically without any-
further warning.
22 / 64

Battery operating time

Antenna alignment

Transmitter Commissioning

Turn on the transmitter

Initial setup of the transmitter

33040_mc32exHoTT_V1.00_en 33040_mc32exHoTT_V1.00_en
The operating time of the battery is added up with each use. The
clock is reset to the value „0:00" when the battery is charged or
replaced. However, this only happens if the battery voltage is
noticeably higher than before. As a default, the battery operating
timer, like the model operating timer, can be found in the „Clock
Info" submenu of the basic menu. However, each of these two
clocks is also available as a widget for insertion into an individu-
alized main menu.
In model operation, the surface of the antenna should be aligned
towards the model roughly.
Sliding the power switch to the left turns on the mc-32ex HoTT
transmitter.
If the transmitter is still in delivery status or if it was previously reset
to the factory settings in the „Info & Update" menu, an almost
self-explanatory wizard starts immediately after switching on the
transmitter.
The questions of the first four displays can be answered by tap-
ping on the selection field that you want.
Tapping the symbol „ " at the right side of the dispaly switches to
the next display and tapping the symbol („ ") at the left side
switches backward to the last display.
Control modes
• (Airplane models)
MODE 1 (Throttle right) MODE 2 (Throttle left)
Elevator Full throttle Full throttle Elevator
Elevator Motor idle Motor idle Elevator
MODE 3 (Throttle right) MODE 4 (Throttle left)
Elevator Full throttle Full throttle Elevator
Elevator Motor idle Motor idle Elevator
23 / 64