Thr.crv; Changing The Control Direction - GRAUPNER mz-24 Pro Programming Manual

THR.CRV

Setting the control characteristic of the Throttle control stick
This sub-menu is not displayed, depending on the con-
fi guration of a glider "with or without motor".
In the basic transmitter display, use your fi nger or the
provided stylus to touch the gear icon labeled "F":
000%
000:00.0
000 000
mz
0:01:23 000:00.0
Touch
M - 1
000 000
PHASE 1
MODELLNAME 1
BATT TIME 00: 01: 23
000
The display switches to the blue function menu. Touch
the menu item "THR.CRV".
BACK BASE FUNCTION
Phase D/R,EXP THR.CRV Prog.MIX
Touch
Logical sw Sequence
In this sub-menu, you can adapt the control charac-
teristic as well as the idle LOW or "motor off" position
of the throttle.
This menu allows you to change the control charac-
teristic of the throttle and control stick independent of
whether the control function acts directly on a servo
connected to control channel 1, or via a number of
mixers on several servos.
128 Function menu | general - Curve CH 1
Phase depending settings
The here mentioned sub-menu offers the possibility
of phase specifi c settings. Recognizable on the top
left side of the display in green color is displayed the
phase name. As standard is displayed the name of the
phase 1, which is indicated by the name "NORMAL"
or "PHASE 1". As soon as you will have defi ned one
or many other phases in the "PHASE" menu, you will
000%
be able to switch among those phases. Activate the
4.2V
corresponding switch or switches if desired to switch
between the phases.

Changing the control direction

In the wing program of the mz-24 HoTT Pro trans-
mitter, the rear throttle position is the default for the
"motor off" position with electric drives. Not only in
000
this special case the control direction of throttle con-
trol stick can be inverted through the throttle curve
from "accelerate from back to front" to "accelerate
SYSTEM
from front to back".
Turn on the graphic and numerical display of the
control stick position by touching the
Trainer
ton at the bottom left of the display and then acti-
vate the Y-coordinate adjustment option by touching
Y-axis
the button:
Use the throttle to move a vertical green line between
the two endpoints "L" and "H" in the graphic.
ST OFF
BACK PHASE 1 TRH.CRV SERVO
CURVE OFF
IN INC
–100%
OUT –100%
DEC
POINT L 000%
ST ON X-axis Y-axis ENT
The momentary control stick position is also displayed
numerically in the line "IN"(put) (-100 % to +100 %).
Then move the throttle to one of the two end positions
such as the front. The green line moves the right and
disappears under the white frame. At the same time,
the color of the point at the top right changes from
green to red:
BACK PHASE 1
CURVE
IN
OUT
POINT
ST ON
Hold down the "-" button at the right edge of the dis-
play to move the red point down to a value of 000%
in the line "POINT":
BACK PHASE 1
but- CURVE
IN
OUT
POINT
ST ON
Then move the throttle to the opposite end position,
such as the rear. The green line moves to the left, and
the points at the ends of the yellow horizontal line
change color:
THR.CRV SERVO
OFF
INC
+100%
+100%
DEC
L +100%
X-axis Y-axis ENT
THR.CRV SERVO
OFF
+100% INC
–100%
H 000% DEC
X-axis Y-axis ENT