Ar Throttle Position; Thr.hold - GRAUPNER mz-24 Pro Programming Manual

THR.HOLD

AR throttle position

In the basic transmitter display, use your fi nger or the
provided stylus to touch the gear icon labeled "F":
000%
000:00.0
000 000
mz
0:01:23 000:00.0
Touch
M - 3
000 000
PHASE 1
Starlet
BATT TIME 00: 01: 23
000
The display switches to the blue function menu. Touch
the menu item "THR.HOLD":
BACK BASE FUNCTION
Phase D/R,EXP PIT.CRV THR.CRV
THR.HOLD Swash S.Limit S.MIX
Touch
Prog.MIX Trainer PIT>>TAIL Logical sw
AR throttle position
BACK PHASE 1 THR.HOLD
ACT INH
CTL ON
  SET –100%
During competition, is expected that gas engines
should be completely turned off. In the training phase,
this is a bit inconvenient since you would have to re-
start the motor after each autorotation landing.
170 Function menu | Helicopter model - THR AR
Therefore, set the value during the training phase in
this display so that the gas motor can be kept idling
during the autorotation phase without the clutch en-
000%
gaging, and so that any electric drive is defi nitely off.
4.2V
Tip
With the "Thr.CUT" option in the Base menu, there is an
alternative emergency off function.
• ACT line
000
To turn this option on and off, touch the value fi eld
of the "ACT" line, for example:
SYSTEM
Gyr/Gover
THR.MIX
Sequence
• Ctrl/sw line
In this line, as described in the
assignment
SERVO
which you switch to the autorotation phase, for ex-
ample:
INC
RES
DEC
BACK PHASE 1 THR.HOLD SERVO
INC
ACT ON
CTL ON RES
  SET –100% DEC
Control and switch
section, assign the same switch with
BACK PHASE 1 THR.HOLD SERVO
INC
ACT ON
CTL SW 3 RES
  SET –100% DEC
• SET line
The green arrow to the left of the bar graph indi-
cates the current, infl uenced by the actual posi-
tion of the Throttle/pitch control stick ao as by the
throttle limit, position of the throttle servo. The red
arrow to the right indicates the currently set auto-
rotation throttle position, as standard -100%.
To change the current autorotation throttle posi-
tion, use the throttle/pitch control stick to move
the green arrow, and possibly the throttle trim, to
the position that the throttle servo is to assume
during autorotation, for example:
BACK PHASE 1 THR.HOLD
ACT ON
CTL SW 3
 SET –100%

Touch the value fi eld of this "SET" line:
BACK THR.HOLD
PHASE 1
ACT ON
Touch
CTL SW 3
 SET –100%

The color of the fi eld switches from black to blue:
SERVO
INC
RES
DEC
SERVO
INC
RES
DEC