Additional Functions - GRAUPNER mz-24 Pro Programming Manual

BACK PHASE 1 PIT.CRV
Pitch min FORWARD
CURVE OFF
IN –036%
OUT 000%
POINT 2 000%
ST ON X-axis Y-axis
Touch the X-axis blue button again to deactivate
the function. The button color changes again to
red.
Notices
• If you move the red point horizontally away
from the current control position, the point
becomes green after a short while, and a
"?" appears in the Point line. This question
mark does not relate to the point which
has been moved but rather indicates that
another point can be set at the current
control position.
• Remember that the percentages in the
"IN"(put) and "OUT"(put) line always refer
to the momentary position of the control
stick and not to the position of the point.
• Y-axis button
Activate this function by touching the button at
the bottom edge of the display. The button color
changes from red to blue:
You can then move an active (red) point to the right
with the + button, and to the left with the
ton, for example:
156 Function menu | Helicopter model - Pitch curve
SERVO BACK
TRIM
Pitch min
INC
DEC
ENT
Touch the Y-axis
the function. The button color changes again to
red.
Notice
Remember that the percentages in the "IN-
"(put) and "OUT"(put) line always refer to the
momentary position of the control stick and
not to the position of the point.
Rounding off the throttle curve
• ON / OFF buttons in the "Curve" line
The default angled curve profile can be automati-
cally rounded off by turning on the rounding func-
tion by pressing this button, for example:
BACK
Pitch min
(Y-axis)
- but-
PHASE 1 PIT.CRV SERVO
TRIM
FORWARD
CURVE OFF
INC
IN –036%
OUT +027%
DEC
POINT 2 +027%
ST ON X-axis Y-axis ENT
blue button again to deactivate
PHASE 1 PIT.CRV SERVO
TRIM
FORWARD
CURVE OFF
INC
IN –036%
Touch
OUT +027%
POINT 2 +027% DEC
ST ON X-axis Y-axis ENT
BACK PHASE 1 PIT.CRV
Pitch min FORWARD
CURVE ON
IN –036%
OUT +027%
POINT 2 +027%
ST ON X-axis Y-axis
Notice
The curves portrayed here are for demonstra-
tion purposes only and do not represent real
pitch curves.

Additional functions

• TRIM buttons
The mz-24 HoTT Pro transmitters has a func-
tion that is integrated in the helicopter program
for trimming up to six support points of the two
options "throttle curve" and "pitch curve" during
flight through the transmitter software.
Touch the TRIM button at the top right edge of the
display with a finger or the provided stylus to open
the corresponding display:
BACK PHASE 1 PIT.CRV
Pitch min FORWARD
CURVE ON
IN –036%
OUT +027%
POINT 2 +027%
ST ON X-axis Y-axis
SERVO
TRIM
INC
DEC
ENT
SERVO
TRIM
Touch
INC
DEC
ENT