GRAUPNER mz-24 Pro Programming Manual page 61

1SERVO NOR 2SERVO 180 3S 120(Roll)
3SERVO 140 3S 120(2Nick) 4 SERVO 90
... etc. For the remainder of the process, you only
need to use the assistant as described in the men-
tioned section until all the basic settings of the newly
selected model type are entered.
Basically, use the same procedure as you would, for
example, to change the wing type of the current mod-
el from "1AILE" to "2AILE 2FLAP'. In this case tap on
the button under "Wing Type" ...
BACK
M/TYPE W/TYPE MOTOR
NORMAL
1AILE
T/TYPE
AIRPLANE ELECTRIC POWER
Touch
NORMAL
... and change the wing type in the display "Wing
Type" that appears...
WING Type NORMAL
1AILE 1AILE 1FLAP 2AILE 2AILE 1FLAP
2AILE 2FLAP 2AILE 4FLAP 4AILE 2FLAP 4AILE 4FLAP
... by touching the desired "new" wing type. Use the
same procedure for all of the selectable fi elds.
The entire process is concluded by touching the
button at the lower right side of the display which re-
sumes all the selected options, for example:
M/TYPE W/TYPE P/TYPE
NORMAL
2A 2F
T/TYPE
ELE. POWER
MOTOR
NORMAL
Notices
• In the model type "BOAT", the only possible
selection is basically between motor powered
or non motor powered model type:
BACK
M/TYPE P/TYPE
BOAT POWER
• In the model type "CAR" and "COPTER", the
only possible selection is basically the model
type:
ENT
Touch
ENT
BACK
COPTER
ENT
Base menu - Model type 61