GRAUPNER mz-24 Pro Programming Manual page 100

Specifically if there is the possibility of reciprocal interfe-
rence of the back-channels, as for example in a camera
drone with separate camera and copter control or a to-
wing model for model-parachute.
RES
Touch the button to reset a changed value in the
blue (and hence active) field to the default value.
Switch between the individual pages of the "Telem-
etry" menu by touching the ENT
ESC
and (reverse or) with a finger at a provided sty-
lus. Corresponding pointers indicating direction can
be found on each page of the display at the top right
in the form of angled brackets " " or " ", such as:
BACK
Telemetry
RECE
RX SERVO V6.35<>
>OUTPUT CH: 01
GENE
REVERSE : OFF
CENTER : 1500µsec ELEC
TRIM : –000µsec
VARIO
LIMIT– : 150%
LIMIT+ : 150% GPS
PERIOD : 20msec
ESC
If there is only one angled bracket, you are on the first
or last page. You can then only change pages in the
displayed direction.
Menu lines in which parameters can be changed are
indicated by a preceding angle bracket (see screen-
shot above). Touch the INC or DEC
the " " pointer one line up or down. Lines which can-
not be jumped cannot be changed.
To change a parameter, touch the
right edge of the screen. The selected parameter is
represented in white.
100 Function menu - Telemetry
>OUTPUT CH: 01
button (forward)
Then use the
selected value within the possible range; the changed
value is confirmed and stored in the receiver memory
by touching one more time the SET button.
Touch the ESC
to return to the previous page and touch the
button at the top left of the display to return to the
ESC
initial position:
DEC
INC
ENT
SET
Notices
button to move • If however the following message appears
instead of the desired sub-menu, then there
is no connection with the receiver. Switch on
your receiver system or
SET button at the
ing receiver or activate it in the "RX SELECT"
line as described before.
BACK Telemetry
RECE ESC
RX SERVO V6.35<>
GENE DEC
REVERSE : OFF
INC
CENTER : 1500µsec ELEC
TRIM : –000µsec
VARIO ENT
LIMIT– : 150%
LIMIT+ : 150% GPS SET
PERIOD : 20msec
ESC
INC or DEC buttons to change the
button at the top right of the display
BACK
Telemetry
RX SELECT RX1 ALWAYS
>>
SETTING & DATA VIEW
SENSOR >> INC
>>
RF STATUS VIEW RES
>> DEC
VOICE TRIGGER
bind the correspond-
• If, however, you have opened one of the sub-
menus described below and this is unex-
pectedly replaced by, as the selection menu
shown below, then the connection to your
receiving system is lost. Then switch on the
receiver system again or solve find the origin
of the connection failure.
Touch the button of the desired sub-menu.
BACK