Program Description - GRAUPNER mz-24 Pro Programming Manual

Program description

As already mentioned in section
plays, you can touch one of the four gear icons at the
bottom right of the basic display identifi ed with "B",
"F", "S" and T...
000%
000:00.0
000 000
mz
0:01:23 000:00.0
M - 1
000 000
PHASE 1
MODELLNAME 1
BATT TIME 00: 01: 23
000
... to open the respective selection menu.
These sub menus contain all of the setting and display
menus required to program a model as well as the
transmitter.
The description of the individual menu items starting
on page 38 is offered in the sequence provided by
the transmitter.
Notice
The display screen-shots of this manual are in-
tended for illustration purpose only. Therefore
please note that the represented settings and
setting values cannot be used for 1:1 reference.
34 Program description
"B"
Operating the dis-
Touch the gear icon labeled "S" with a fi nger or with
000%
the provided stylus:
4.2V
000
This menu contains all of the base setting and display
menus that are needed to set up the model:
Name
MOD.SEL.
Model Type
E.P.A
REV/SUB
THT.CUT
TX ctl
Timer
Fail Safe
Trim Step
Servo
CTL Set
Out.Swap
Telemetry
Announce
* hidden for models without a motor
("green" basis menu)
BACK BASE FUNCTION SYSTEM
Model Sel Model Type E.P.A REV/SIB Motor
TX ctl Timer Fail Safe Trim Step Servo
CTL Set Out.Swap Telemetry Announce
Menu Page
"Model Sel"
"Model type"
"Servo path/servo limit"
"Servo reverse/servo sub-
trim"
"Throttle Cut"*
"Transmitter controls"
"Timer"
"Fail Safe"
"Trim step"
"Servo monitor"
"Control setting"
"Transmitter output"
"Telemetry setting"
"Announce"
"F"
Touch the gear icon labeled "F" with a fi nger or with
the provided stylus:
Depending on the model type of the currently active
model memory, different menu structures are dis-
played. These can also vary depending on the basic
settings of the model. The following menu represen-
tations therefore only offer a selection as an example:
BACK BASE
Phase D/R,EXP
Logical sw Sequence
38
60
Name
62
Phase "Phase setting"
64
D/R,EXP "Dual rate, Expo"
THR.CRV "Throttle curve"
66
Prog.MIX "Free mixers"
68
Trainer "Trainer system"
74
Logical sw "Logical switch"
80
Sequence "Sequencer"
82
86
For reasons of space the description of these "general
90 menus" in the next paragraphs will not be repeated be-
cause the sub-menus are contained also in the "blue"
96
menus of the model type "helicopter" and "airplane".
98
However, for major clarity, these "general menus" have
118
been integrated both in the
charts according to the sequence.
("blue" function menu)
FUNCTION SYSTEM
THR.CRV Prog.MIX Trainer
Menu Page
120
124
128
134
141
148
150
Index and in the following