Control Switch Assignment; Assigning Logical Switch; Canceling The Switch Assignment - GRAUPNER mz-24 Pro Programming Manual

Canceling the switch assignment

After the switching assignment has been activat-
ed as described at the beginning of this section,
N
touch the button.
Select
NO
CLR
touch
LOGIC

• Control switch assignment

Move the control that you want to use to activate
the switching function, for example the control
function 3, indicated with "SL2":
BACK
CTL ST 3
POS 000

MODE SINGLE
DIR REVERSE
The yellow arrow to the right of the bar diagram
illustrates the current control position which can
ENT
be accepted by touching the
switching point in the value field to the right of
"POS". Reverse the switching direction by touch-
ing REV in the line "DIR(ection)".
In the "MODE" line, the switching function of the
control switch can be changed from on/off like
a 2-stage switch to the switching behavior of a
3-stage switch.
28 Control and switch assignment
Notice
In this case, be sure to specify a switching po-
sition that is not "000". Otherwise, you risk
switching continuously back-and-forth be-
tween the two switching states while the relevant
control is in the middle control position.

• Assigning logical switch

After the switching or control assignment has been
activated as described at the beginning of this sec-
tion, touch the
In the new window appears a list with the eight
logical switches "L1 ... L8" so as 8 inverted logi-
cal switches.
BACK
ENT
button as the
As soon as you tap on the desired switch, it will be
assumed in the output menu, for example:
BACK
LOGIC button:
Select
NO
touch
CLR
LOGIC
Select logical switch
L1 L2 L3 L4
L5 L6 L7 L8
L1i L2i L3i L4i
L5i L6i L7i L8i
PHASE 1 D/R,EXP SERVO
CH AILE
INC
D/R +100% +100%
EXP 000% 000% RES
CTL L1 DEC
SYM OFF
Notice
Therefore do not forget to program the related
selected logical switch in the
sub-menu!
Tips
Through the logical switches, see sub-menu
cal sw", you can logically interconnect two switch-
es and/or also control switch in a "AND" or "OR"
switch.. A total amount of 8 logical switches "L1 ...
L8" (so as 8 accessory logical switches with reversed
switch direction) are available.
The result of one of these logical switch functions
can also be used as switch function in another logi-
cal switch. For more specific details, see the related
menu.
• All of these switches can be given multiple assign-
ments. Make sure that you do not accidentally as-
sign competing functions to a switch. It is recom-
mendable to write down the switching functions.
Practical examples:
• Turning an on-board glow plug heater on and
off when a idling switching point for the THR con-
trol stick is exceeded or undershot. The switch for
the glow plug heater is controlled at the transmitter
by a mixer.
• Automatically turning the stopwatch on and off to
measure the actual flight time of a helicopter by
means of a control switch on the throttle limiter.
• Automatically turning off the mixer "AILE  RUDD"
when the brake flap extends to adapt the landing
position of the model to the ground contour when
landing on a slope without affecting the direction
of flight by rudders which are otherwise involved.
"Logical sw"
"Logi-