Removing The Light Sensor Module - Christie CP2208 Service Manual

3. Remove the lens surround.
4. Remove the front skin. See
5. Remove the yellow notch filter. See
6. Remove the three screws that secure the contrast aperture to the IOS.
7. Slide the aperture out along the slotted tracks inside the IOS.

Removing the light sensor module

The light sensor module, mounted to the side of the IOS, is orientated to sample the light coming
through the fold mirror.
1. Turn the projector off and then disconnect it from AC power.
2. Remove the top lid. See
3. Remove the front skin. See
4. Disconnect the harness from the light sensor module.
5. Remove the two screws that secure the sensor to the IOS—the middle screw is used to adjust
light tolerances.
CP2208 Service Manual
020-101917-01 Rev. 1 (11-2015)
Removing the front skin
Yellow Notch Filter (YNF)
Removing the top lid
Removing the front skin
Parts and Module Replacement
on page 34.
on page 64.
.
on page 33
on page 34.
61