Remove The Radiator Fan (Fan 3); Remove The Light Engine Fan (Fan 4) - Christie CP2215 Service Manual

8. For the cathode blower, remove the 4 screws holding the bracket plate and duct.
9. Remove the 2 screws holding the blower to the duct.

Remove the Radiator Fan (Fan 3)

1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the top lid. See
4. Remove the service door. See
5. Loosen the captive screw securing the radiator air filter door.
6. Tilt the radiator and fan assembly down.
7. Pull the filter upward and out of the radiator housing.
8. Disconnect the inline fan connector.
9. Remove the 4 screws securing the fan to the mounting bracket.
10. Remove and clean the fan and then install its replacement with the airflow directional arrow
facing the direction of the airflow.

Remove the Light Engine Fan (Fan 4)

Use caution when working in and around fan assemblies. Fingers can get caught in fan
blades. Failure to comply results in death or serious injury.
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the top lid. See
CP2215 Service Manual
020-101226-03 Rev. 1 (10-2015)
Remove the Top Lid on page 22.
Remove the Exhaust Panel Skin
Remove the Top Lid on page 22.
Parts and Module Replacement
on page 26.
47