Removing The Light Engine Blower (Fan 3) - Christie CP2208 Service Manual

4. Remove the three screws holding the lamp adjust cable plate to the blower.
5. Loosen the set screws securing the flexible shafts to the lamp adjust and then disconnect the
flexible shafts.
6. Remove the two screws securing the internal touch panel controller (TPC) harness.
7. Disconnect the cathode blower fan harness.
8. Loosen the three thumbscrews securing the cathode to the center structure.
9. Remove the cathode blower assembly through the top of the projector.
10. Remove the four screws holding the bracket plate and duct.
11. Remove the two screws holding the blower to the duct.

Removing the light engine blower (fan 3)

Danger! Failure to comply with the following results in serious injury.
Use caution when working in and around fan assemblies. Fingers can get caught in fan blades.
The light engine intake fan draws filtered air through the front air filter.
1. Turn the projector off and then disconnect it from AC power.
2. Remove the top lid. See
3. Remove the service door. See
4. Loosen the two captive screws securing the filter access door and then remove the filter access
door.
5. Remove the two captive screws securing the fan to the center structure.
Remove the card cage. See
6. Disconnect the number three fan harness.
7. Lift the fan up and away from the rubber isolators.
CP2208 Service Manual
020-101917-01 Rev. 1 (11-2015)
Removing the top lid
Removing the service door
Removing the card cage
Parts and Module Replacement
on page 33.
on page 38.
.
on page 54 .
58