Cisco ASA 5505 Configuration Manual page 568

Configuring Twice NAT
Figure 28-10
Set the source and destination interfaces.
Step 2
By default, both interfaces are set to --Any--.
a. From the Match Criteria: Original Packet > Source Interface drop-down list, choose the source
interface.
From the Match Criteria: Original Packet > Destination Interface drop-down list, choose the
b.
destination interface.
Figure 28-11
Identify the original packet addresses (the real source address and the mapped destination address).
Step 3
For the Match Criteria: Original Packet > Source Address, click the browse button
a.
existing network object or group from the Browse Original Source Address dialog box. The default
is any.
Figure 28-12
You can also create a new named object or group from the Browse Original Source Address dialog
box and use this object or group as the real source address.
(Optional) For the Match Criteria: Original Packet > Destination Address, click the browse button
b.
dialog box.
Cisco ASA 5500 Series Configuration Guide using ASDM
28-8
Add NAT Rule Dialog Box
Setting the Interfaces
Browse Dialog Box
and choose an existing network object or group from the Browse Original Destination Address
Chapter 28 Configuring Twice NAT
and choose an
OL-20339-01