Cisco ASA 5505 Configuration Manual page 439

Chapter 23 Configuring EIGRP
Click OK.
Step 8
Click the Networks tab.
Step 9
Click Add to add a new network entry.
Step 10
The Add EIGRP Network dialog box appears. To remove a network entry, select the entry in the table
and click Delete.
Choose the AS number of the EIGRP routing process from the drop-down list.
Step 11
In the IP Address field, enter the IP address of the networks to participate in the EIGRP routing process.
Step 12
To change a network entry, you must first remove the entry and then add a new one. You cannot edit
Note
existing entries.
In the Network Mask field, choose or enter a network mask to apply to the IP address.
Step 13
Click OK.
Step 14
Choose Configuration > Device Setup > Routing > EIGRP > Static Neighbor.
Step 15
Click Add to add a static neighbor.
Step 16
The Add EIGRP Neighbor Entry dialog box appears.
Choose the EIGRP AS number from the drop- down list for which the EIGRP process the neighbor is
Step 17
being configured.
Choose the Interface Name through which the neighbor is available from the Interface Name drop-down
Step 18
list.
Enter the IP address of the neighbor in the Neighbor IP Address field.
Step 19
Click OK.
Step 20
Choose Configuration > Device Setup > Routing > EIGRP > Interfaces.
Step 21
The Interface pane appears and displays the EIGRP interface configurations.
Double-click an interface entry or choose the entry and click Edit.
Step 22
The Edit EIGRP Interface Entry dialog box appears.
Step 23 Choose the EIGRP Autonomous system (AS) number from the drop-down list.
This list is populated from system numbers that were set up when you enabled the EIGRP routing
process.
Enter the delay value in the Delay field. The delay time is in tens of microseconds. Valid values are from
Step 24
1 to 16777215.
Click OK.
Step 25
OL-20339-01
Cisco ASA 5500 Series Configuration Guide using ASDM
Configuration Example for EIGRP
23-19