Cisco ASA 5505 Configuration Manual page 296

DHCP Monitoring
Click OK to close the Advanced DHCP Options dialog box.
Step 2
Step 3 Click Apply to save your changes, or click Reset to discard them and enter new ones.
DHCP Monitoring
To monitor DHCP, perform the following steps:
Path
Tools > Command Line Interface
Type show running-config dhcpd, then click Send.
Tools > Command Line Interface
Type show running-config dhcprelay, then click Send.
Monitoring > Interfaces > DHCP > DHCP Client Lease
Information
Monitoring > Interfaces > DHCP > DHCP Server Table
Monitoring > Interfaces > DHCP > DHCP Statistics
Cisco ASA 5500 Series Configuration Guide using ASDM
10-8
The name of the associated IP Address fields can change based on the DHCP option that you
Note
chose. For example, if you choose DHCP Option 3 (Router), the fields names change to
Router 1 and Router 2.
Click ASCII to specify that an ASCII value is returned to the DHCP client. In the Data field,
–
enter an ASCII character string. The string cannot include white spaces.
Note The name of the associated Data field can change based on the DHCP option that you chose.
For example, if you choose DHCP Option 14 (Merit Dump File), the associated Data field
names change to File Name.
Click Hex to specify that a hexadecimal value is returned to the DHCP client. In the Data field,
–
enter a hexadecimal string with an even number of digits and no spaces. You do not need to use
a 0x prefix.
The name of the associated Data field can change based on the DHCP option you chose. For
Note
example, if you choose DHCP Option 2 (Time Offset), the associated Data field becomes the
Offset field.
Purpose
Shows the current DHCP configuration.
Shows the current DHCP relay services status.
Shows configured DHCP Client IP addresses.
Shows configured dynamic DHCP Client IP addreses.
Shows DHCP message types, counters, values, directions,
messages received, and messages sent.
Chapter 10 Configuring DHCP
OL-20339-01