Cisco ASA 5505 Configuration Manual page 529

Chapter 27 Configuring Network Object NAT
Figure 27-8
•
•
You return to the Add/Edit Network Object dialog box.
Click OK, and then Apply.
Step 9
Configuring Dynamic PAT (Hide)
This section describes how to configure a dynamic PAT (hide) rule using network object NAT. For more
information, see the
Detailed Steps
You can add NAT to a new or existing network object:
Step 1
•
OL-20339-01
Configuring Advanced NAT Settings
To translate the IP address in DNS replies, check the Translate DNS replies for rule check box.
Be sure DNS inspection is enabled (it is enabled by default). See the
page 26-21 for more information.
To specify the real and/or mapped interfaces where this NAT rule should apply, under Interface,
choose the source and destination interfaces.
By default, the rule applies to all interfaces.
"Dynamic PAT" section on page
To add a new network object, choose Configuration > Firewall > NAT Rules, then click Add >
Add Network Object NAT Rule.
26-10.
Cisco ASA 5500 Series Configuration Guide using ASDM
Configuring Network Object NAT
"DNS and NAT" section on
27-7