Cisco ASA 5505 Configuration Manual page 413

Chapter 22 Configuring RIP
•
•
Click Apply.
Step 6
Configuring the RIP Send and Receive Version on an Interface
You can override the globally-set version of RIP that the adaptive security appliance uses to send and
receive RIP updates on a per-interface basis.
To configure the RIP version for sending and receiving updates, perform the following steps:
In the main ASDM window, choose Configuration > Device Setup > Routing > RIP > Setup.
Step 1
Check the Enable RIP routing box, and click Apply.
Step 2
Choose Configuration > Device Setup > Routing > RIP > Interfaces.
Step 3
Click Edit.
Step 4
The Edit RIP Interface Entry dialog box appears and allows you to configure the interface-specific RIP
settings for sending and receiving.
In the Send Version area, check the Override global send version check box to specify the RIP version
Step 5
sent by the interface. Choose one of the following:
•
•
•
OL-20339-01
Version 2
–
Version 1 & 2
–
Unchecking this check box restores the global setting.
Override Global Receive Version—Check this check box to specify the RIP version accepted by
the interface. If a RIP updated from an unsupported version of RIP is received by the interface, it is
dropped. Choose one of the following options:
– Version 1
Version 2
–
Version 1 & 2
–
Unchecking this check box restores the global setting.
Enable Authentication—Check this check box to enable RIP authentication. Uncheck this check
box to disable RIP authentication.
Key—The key used by the authentication method, which can be up to 16 characters long.
–
Key ID—The key ID. Valid values are from 0 to 255.
–
Authentication Mode—You can choose one of the following authentication modes:
–
MD5—Uses MD5 for RIP message authentication.
Text—Uses cleartext for RIP message authentication (not recommended).
Version 1
Version 2
Version 1 & 2
Unchecking this check box restores the global setting.
Cisco ASA 5500 Series Configuration Guide using ASDM
Customizing RIP
22-7