Cisco ASA 5505 Configuration Manual page 75

Chapter 1 Introduction to the Cisco ASA 5500 Series Adaptive Security Appliance
Unsupported Commands
ASDM supports almost all commands available for the adaptive adaptive security appliance, but ASDM
ignores some commands in an existing configuration. Most of these commands can remain in your
configuration; see Tools > Show Commands Ignored by ASDM on Device for more information.
This section includes the following topics:
•
•
•
•
Ignored and View-Only Commands
Table 1-5
cannot be added or edited in ASDM. If ASDM ignores the command, it does not appear in the ASDM
GUI at all. If the command is view-only, then it appears in the GUI, but you cannot edit it.
Table 1-5
Unsupported Commands
capture
coredump
dhcp-server (tunnel-group name
general-attributes)
eject
established
failover timeout
ipv6 nd prefix
pager
pim accept-register route-map
prefix-list
service-policy global
set metric
sysopt nodnsalias
OL-20339-01
Ignored and View-Only Commands, page 1-13
Effects of Unsupported Commands, page 1-14
Discontinuous Subnet Masks Not Supported, page 1-14
Interactive User Commands Not Supported by the ASDM CLI Tool, page 1-14
lists commands that ASDM supports in the configuration when added through the CLI, but that
List of Unsupported Commands
ASDM Behavior
Ignored.
Ignored. This can be configured only using the
CLI.
ASDM only allows one setting for all DHCP
servers.
Unsupported.
Ignored.
Ignored.
Unsupported.
Ignored.
Ignored. You can configure only the list option
using ASDM.
Ignored if not used in an OSPF area.
Ignored if it uses a match access-list class. For
example:
access-list myacl line 1 extended permit ip
any any
class-map mycm
match access-list mycl
policy-map mypm
class mycm
inspect ftp
service-policy mypm global
Ignored.
Ignored.
Cisco ASA 5500 Series Configuration Guide using ASDM
Unsupported Commands
1-13