Feature History For The Startup Wizard - Cisco ASA 5505 Configuration Manual

Chapter 7 Using the Startup Wizard
•
•
On the IPv6 Interface Settings tab, do the following:
Step 3
•
•
•
Click Next to continue.
Step 4

Feature History for the Startup Wizard

Table 7-3
backwards-compatible with multiple platform releases, so the specific ASDM release in which support
was added is not listed.
Table 7-3 Feature History for the Startup Wizard
Feature Name Platform Releases
Startup Wizard 7.0(1)
OL-20339-01
To obtain an IP address from a PPPoE server, click the Use PPPoE radio button.
To obtain an IP address from a DHCP server, click the Use DHCP radio button.
To obtain an IP address for the default gateway using DHCP, check the Obtain default route
–
using DHCP check box.
To enable the IPv6 interface, check the Enable IPv6 for the Interface check box.
To add an IPv6 interface address, check the Add an IPv6 Address check box.
Specify the IPv6 address and prefix length (for example, fe80:aabb::). Multiple addresses with
prefixes are allowed; however, no two addresses can be repeated within the list of addresses.
To configure an address using the EUI 64-bit interface identifier format, check the EUI 64 check
–
box.
lists each feature change and the platform release in which it was implemented. ASDM is
Feature Information
This feature was introduced.
Feature History for the Startup Wizard
Cisco ASA 5500 Series Configuration Guide using ASDM
7-29