Cisco ASA 5505 Configuration Manual page 418

Monitoring RIP
In the main ASDM window, choose Configuration > Device Setup > Routing > RIP > Setup.
Step 1
Check the Enable RIP routing check box, and click Apply. If you uncheck this check box, the adaptive
Step 2
security appliance sends RIP Version 1 updates and accepts RIP Version 1 and Version 2 updates. You
can override this setting on a per-interface basis in the Interface pane. Version 1 specifies that the
adaptive security appliance only sends and receives RIP Version 1 updates. Any Version 2 updates
received are dropped. Version 2 specifies that the adaptive security appliance only sends and receives
RIP Version 2 updates. Any Version 1 updates received are dropped.
Choose Configuration > Device Setup > Routing > RIP > Interface.
Step 3
Click Edit.
Step 4
The Edit RIP Interface Entry dialog box appears, which allows you to configure the interface-specific
RIP settings.
In the Authentication area, check the Enable Authentication check box to enable RIP authentication.
Step 5
Uncheck this check box to disable RIP authentication.
In the Key field, enter the key used by the authentication method.
Step 6
This entry can include up to 16 characters.
In the Key ID field, enter the key ID. Valid values range from 0 to 255.
Step 7
Choose the type of Authentication mode that you want to use by clicking the radio button next to one of
Step 8
the following:
•
•
Click Apply.
Step 9
Restarting the RIP Process
To remove the entire RIP configuration, perform the following steps:
In the main ASDM window, choose Configuration > Device Setup > Routing > RIP > Setup.
Step 1
Click Reset.
Step 2
Monitoring RIP
To monitor or display various RIP routing statistics in ASDM, perform the following steps:
In the main ASDM window, choose Monitoring > Routing > Routes.
Step 1
From this pane, you can choose to monitor the following:
Step 2
•
•
Cisco ASA 5500 Series Configuration Guide using ASDM
22-12
MD5 to use MD5 for RIP message authentication.
cleartext to use cleartext for RIP message authentication (not recommended).
IPv4
IPv6
Chapter 22 Configuring RIP
OL-20339-01