Cisco ASA 5505 Configuration Manual page 492

Configuring a Static IPv6 Neighbor
Configuring a Static IPv6 Neighbor
This section includes the following topics:
•
•
•
•
•
•
Information About a Static IPv6 Neighbor
You can manually define a neighbor in the IPv6 neighbor cache. If an entry for the specified IPv6 address
already exists in the neighbor discovery cache—learned through the IPv6 neighbor discovery
process—the entry is automatically converted to a static entry. Static entries in the IPv6 neighbor
discovery cache are not modified by the neighbor discovery process
Licensing Requirements for Static IPv6 Neighbor
The following table shows the licensing requirements for this feature:
Model License Requirement
All models Base License.
Guidelines and Limitations
This section includes the guidelines and limitations for this feature.
Context Mode Guidelines
Supported in single and multiple context mode.
Firewall Mode Guidelines
Supported in routed mode only. Transparent mode is not supported.
Default Settings
Table 25-12
Table 25-12
Parameters
Static IPv6 neighbor
Cisco ASA 5500 Series Configuration Guide using ASDM
25-18
Information About a Static IPv6 Neighbor, page 25-18
Licensing Requirements for Static IPv6 Neighbor, page 25-18
Guidelines and Limitations, page 25-18
Default Settings, page 25-18
Configuring a Static IPv6 Neighbor, page 25-19
Feature History for Configuring a Static IPv6 Neighbor, page 25-20
lists the default settings for static IPv6 neighbor parameters.
Default Static IPv6 Neighbor Parameters
Chapter 25 Configuring IPv6 Neighbor Discovery
Default
Static entries are not configured in the IPv6
neighbor discovery cache.
OL-20339-01