Cisco ASA 5505 Configuration Manual page 528

Configuring Network Object NAT
Define the NAT pool addresses, and click OK.
b.
Figure 27-6
Note
Choose the new network object by double-clicking it. Click OK to return to the NAT configuration.
c.
Figure 27-7
Step 7 (Optional) To use the interface IP address as a backup method when the other mapped addresses are
already allocated, check the Fall through to interface PAT (dest intf) check box, and choose the
interface from the drop-down list.
(Optional) Click Advanced, and configure the following options in the Advanced NAT Settings dialog
Step 8
box. When you are finished, click OK.
Cisco ASA 5500 Series Configuration Guide using ASDM
27-6
Defining the NAT Pool Addresses
Although not disallowed, you will typically not configure NAT for this network object that you
are using for the mapped addresses; you can leave the NAT section unconfigured.
Choosing the New Network Object
Chapter 27 Configuring Network Object NAT
OL-20339-01