Cisco ASA 5505 Configuration Manual page 373

Chapter 19 Configuring Static and Default Routes
Configuration Examples for Static or Default Routes
The following example shows how to configure static routes:
Step 1 In the main ASDM window, choose Configuration > Device Setup > Routing > Static Routes.
Step 2 Choose Management from the Interfaces drop-down list.
Step 3 Enter 10.1.1.0 in the IP Address field.
Choose 255.255.255.0 from the Mask drop-down list.
Step 4
Enter 10.1.2.45 1 in the Gateway IP field.
Step 5
In this step, a static route is created that sends all traffic destined for 10.1.1.0/24 to the router (10.1.2.45)
connected to the inside interface.
Click OK.
Step 6
Choose Configuration > Device Setup > Routing > Static Routes.
Step 7
Click Add.
Step 8
Enter the IP Address in the IP Address field for the destination network.
Step 9
In this case, the IP routes are: 192.168.1.1, 192.168.1.2, 192.168.1.3, and 192.168.1.4. When adding
192.168.1.4, click the Tunneled radio button in the Options area.
Enter the Gateway IP Address in the Gateway IP Address field for the address of the next-hop router.
Step 10
The addresses you specify for the static route are the addresses that are in the packet before entering the
adaptive security appliance and performing NAT.
Choose the netmask for the destination network from the NetMask drop-down list.
Step 11
Click OK.
Step 12
Feature History for Static and Default Routes
Table 19-1
backwards-compatible with multiple platform releases, so the specific ASDM release in which support
was added is not listed.
Table 19-1 Feature History for Static and Default Routes
Feature Name
Routing
OL-20339-01
lists each feature change and the platform release in which it was implemented. ASDM is
Platform
Releases
7.0(1)
Configuration Examples for Static or Default Routes
Feature Information
The route command was introduced to enter a static or
default route for the specified interface.
The Configuration > Device Setup > Routing screen was
introduced.
Cisco ASA 5500 Series Configuration Guide using ASDM
19-9