Asa 5510 And Higher Default Configuration - Cisco ASA 5505 Configuration Manual

Chapter 2 Getting Started
switchport access vlan 1
no shutdown
interface Ethernet 0/2
switchport access vlan 1
no shutdown
interface Ethernet 0/3
switchport access vlan 1
no shutdown
interface Ethernet 0/4
switchport access vlan 1
no shutdown
interface Ethernet 0/5
switchport access vlan 1
no shutdown
interface Ethernet 0/6
switchport access vlan 1
no shutdown
interface Ethernet 0/7
switchport access vlan 1
no shutdown
interface vlan2
nameif outside
no shutdown
ip address dhcp setroute
interface vlan1
nameif inside
ip address 192.168.1.1 255.255.255.0
security-level 100
no shutdown
object network obj_any
subnet 0 0
nat (inside,outside) dynamic interface
http server enable
http 192.168.1.0 255.255.255.0 inside
dhcpd address 192.168.1.2-192.168.1.254 inside
dhcpd auto_config outside
dhcpd enable inside
logging asdm informational

ASA 5510 and Higher Default Configuration

The default factory configuration for the ASA 5510 and higher adaptive security appliance configures
the following:
•
•
•
The configuration consists of the following commands:
interface management 0/0
ip address 192.168.1.1 255.255.255.0
nameif management
security-level 100
no shutdown
asdm logging informational 100
asdm history enable
OL-20339-01
The management interface, Management 0/0. If you did not set the IP address, then the IP address
and mask are 192.168.1.1 and 255.255.255.0.
The DHCP server is enabled on the adaptive security appliance, so a PC connecting to the interface
receives an address between 192.168.1.2 and 192.168.1.254.
The HTTP server is enabled for ASDM and is accessible to users on the 192.168.1.0 network.
Cisco ASA 5500 Series Configuration Guide using ASDM
Factory Default Configurations
2-7