Cisco ASA 5505 Configuration Manual page 419

Chapter 22 Configuring RIP
•
Configuration Example for RIP
The following example shows how to enable and configure RIP with various optional processes:
Step 1 In the main ASDM window, choose Configuration > Device Setup > Routing > RIP > Setup.
Step 2 Check the Enable RIP routing check box and click Apply.
Check the Enable default information originate check box.
Step 3
For more information about defining a route map, see the
Check the Enable RIP version check box, and choose Version 1.
Step 4
In the Networks area, enter 225.25.24.225 in the IP Network to Add field.
Step 5
In the Passive Interface area, click the check box next to the interface that you want to be passive in the
Step 6
Passive Interfaces table.
Click Apply.
Step 7
Choose Configuration > Device Setup > Routing > RIP > Redistribution.
Step 8
Click Edit.
Step 9
In the Protocol area, choose Connected.
Step 10
In the Metric area, check the Configure Metric Type check box, and choose Transparent Mode
Step 11
(default).
In the Optional area, choose a route map from the Route Map drop-down list.
Step 12
Click Manage to configure a specific route map. For more information about configuring route maps,
Step 13
see the
Click OK.
Step 14
Feature History for RIP
Table 22-1
backwards-compatible with multiple platform releases, so the specific ASDM release in which support
was added is not listed.
Table 22-1 Feature History for RIP
Feature Name
RIP Support
OL-20339-01
Both
"Add/Edit a Route Map" section on page
lists each feature change and the platform release in which it was implemented. ASDM is
Releases
7.0(1)
"Defining Route Maps" section on page
20-4.
Feature Information
Support for routing data, performing authentication, and
redistributing and monitoring routing information using the
Routing Information Protocol (RIP).
The Configuration > Device Setup > Routing > RIP
screen was introduced.
Cisco ASA 5500 Series Configuration Guide using ASDM
Configuration Example for RIP
20-1.
22-13