Cisco ASA 5505 Configuration Manual page 377

Chapter 20 Defining Route Maps
•
•
•
•
Do not configure a set command in a route map deny clause because the deny clause prohibits route
Note
redistribution—there is no information to modify.
A route map clause without a match or set command, or Match or Set Value as set on the Match or Set
Value tab in ASDM, performs an action. An empty permit clause allows a redistribution of the remaining
routes without modification. An empty deny clause does not allows a redistribution of other routes (this
is the default action if a route map is completely scanned but no explicit match is found).
Licensing Requirements for Route Maps
Model License Requirement
All models Base License.
Guidelines and Limitations
This section includes the guidelines and limitations for this feature.
Context Mode Guidelines
Supported in single context mode.
Firewall Mode Guidelines
Supported only in routed mode. Transparent mode is not supported.
IPv6 Guidelines
Does not support IPv6.
OL-20339-01
If several match commands or Match Clause values in ASDM are present in a clause, all must
succeed for a given route in order for that route to match the clause (in other words, the logical AND
algorithm is applied for multiple match commands).
If a match command or Match Clause value in ASDM refers to several objects in one command,
either of them should match (the logical OR algorithm is applied). For example, in the match ip
address 101 121 command, a route is permitted if access list 101 or access list 121 permits it.
If a match command or Match Clause value in ASDM is not present, all routes match the clause. In
the previous example, all routes that reach clause 30 match; therefore, the end of the route map is
never reached.
If a set command, or Set Value in ASDM, is not present in a route map permit clause, then the route
is redistributed without modification of its current attributes.
Licensing Requirements for Route Maps
Cisco ASA 5500 Series Configuration Guide using ASDM
20-3