Cisco ASA 5505 Configuration Manual page 1018

Configuring Cisco Intercompany Media Engine Proxy
To configure a Cisco Intercompany Media Engine for a basic deployment, perform the following tasks.
Configure static NAT for Cisco UCM. See
Step 1
Proxy, page
Or
Configure PAT for the UCM server. See
Create access lists for Cisco Intercompany Media Engine Proxy. See
Step 2
Intercompany Media Engine Proxy, page
Create the media termination address instance for Cisco Intercompany Media Engine Proxy. See
Step 3
Creating the Media Termination Instance, page
Create the Cisco Intercompany Media Engine Proxy. See
Step 4
Engine Proxy, page
Create trustpoints and generate certificates for the Cisco Intercompany Media Engine Proxy. See
Step 5
Creating Trustpoints and Generating Certificates, page
Create the TLS proxy. See
Step 6
Configure SIP inspection for the Cisco Intercompany Media Engine Proxy. See
Step 7
for the Cisco Intercompany Media Engine Proxy, page
(Optional) Configure TLS within the enterprise. See
Step 8
Enterprise, page
Step 9 (Optional) Configure off path signaling. See
Note
Configuring NAT for Cisco Intercompany Media Engine Proxy
To configure auto NAT, you first configure an object; then use the nat command in the object
configuration mode.
The example command lines in this task are based on a basic (in-line) deployment. See
page 47-11
Alternatively, you can configure PAT for the Cisco Intercompany Media Engine Proxy. See
PAT for the Cisco UCM Server, page
Cisco ASA 5500 Series Configuration Guide using ASDM
47-12
47-12.
47-18.
Creating the TLS Proxy, page
47-28.
You only perform Step 9 when you are configuring the Cisco Intercompany Media Engine Proxy
in an off path deployment.
for an illustration explaining the example command lines in this task.
Chapter 47 Configuring Cisco Intercompany Media Engine Proxy
Configuring NAT for Cisco Intercompany Media Engine
Configuring PAT for the Cisco UCM Server, page
47-16.
47-17.
Creating the Cisco Intercompany Media
47-22.
47-25.
47-26.
(Optional) Configuring TLS within the Local
(Optional) Configuring Off Path Signaling, page
47-14.
47-14.
Creating Access Lists for Cisco
Enabling SIP Inspection
47-31.
Figure 47-6 on
Configuring
OL-20339-01