Cisco ASA 5505 Configuration Manual page 411

Chapter 22 Configuring RIP
Customizing RIP
This section describes how to configure RIP and includes the following topics:
•
•
•
•
•
•
•
•
Configure the RIP Version
In ASDM, you can specify the version of RIP used by the adaptive security appliance by performing the
following steps:
In the main ASDM window, choose Configuration > Device Setup > Routing > RIP > Setup.
Step 1
Check the Enable RIP routing check box, and click Apply.
Step 2
Check the Enable RIP version check box.
Step 3
Checking this check box specifies the version of RIP used by the adaptive security appliance. If this
check box is cleared, then the adaptive security appliance sends RIP Version 1 updates and accepts RIP
Version 1 and Version 2 updates. This setting can be overridden on a per-interface basis in the
pane. For more information about configuring interfaces, see the
section on page
•
•
Click Apply.
Step 4
OL-20339-01
Configure the RIP Version, page 22-5
Configuring Interfaces for RIP, page 22-6
Configuring the RIP Send and Receive Version on an Interface, page 22-7
Configuring Route Summarization, page 22-8
Filtering Networks in RIP, page 22-9
Redistributing Routes into the RIP Routing Process, page 22-10
Enabling RIP Authentication, page 22-11
Restarting the RIP Process, page 22-12
22-6.
Version 1—Specifies that the adaptive security appliance only sends and receives RIP Version 1
updates. Any Version 2 updates received are dropped.
Version 2—Specifies that the adaptive security appliance only sends and receives RIP Version 2
updates. Any Version 1 updates received are dropped.
"Configuring Interfaces for RIP"
Cisco ASA 5500 Series Configuration Guide using ASDM
Customizing RIP
Interface
22-5