Step 1 - Starting Point Or Welcome - Cisco ASA 5505 Configuration Manual

Startup Wizard Screens for the ASA 5505 Adaptive Security Appliance
Table 7-2
Screen Name and Sequence
Step 1 - Starting Point or Welcome, page 7-4
Step 2 - Basic Configuration, page 7-5
Step 3 - Time Zone and Clock Configuration, page 7-5
Step 4 - Auto Update Server, page 7-6
Step 5 - Management IP Address Configuration,
page 7-6
Step 6 - Interface Selection, page 7-6
Step 7 - Switch Port Allocation, page 7-7
Step 8 - Interface IP Address Configuration, page 7-8
Step 9 - Internet Interface Configuration - PPPoE,
page 7-8
Step 10 - Business Interface Configuration - PPPoE,
page 7-9
Step 11 - Home Interface Configuration - PPPoE,
page 7-10
Step 12 - General Interface Configuration, page 7-10
Step 13 - Static Routes, page 7-11
Step 14 - DHCP Server, page 7-11
Step 15 - Address Translation (NAT/PAT), page 7-12
Step 16 - Administrative Access, page 7-13
Step 17 - Easy VPN Remote Configuration, page 7-14
Step 18 - Startup Wizard Summary, page 7-16

Step 1 - Starting Point or Welcome

To change the existing configuration, click the Modify existing configuration radio button.
Step 1
To set the configuration at the factory default values for the inside interface, click the Reset
Step 2
configuration to factory defaults radio button.
To configure the IP address and subnet mask of the management interface, check the Configure the IP
Step 3
address of the management interface check box.
Step 4 Specify the IP address of the management interface.
Step 5 Choose the subnet mask of the management interface from the drop-down list.
Cisco ASA 5500 Series Configuration Guide using ASDM
7-4
Startup Wizard Screens for the ASA 5505 Adaptive Security Appliance
Chapter 7 Using the Startup Wizard
Availability
All modes. The Teleworker option in
- Basic Configuration is available only on
the ASA 5505.
All modes.
Single, routed, and transparent modes.
Enabled only if configured for teleworker
usage.
Single, transparent mode only.
Single, routed mode only.
All modes. Enabled only if configured for
teleworker usage.
All modes.
Single, routed mode only.
All modes.
Single, routed mode, only when enabled for
teleworker usage.
All modes.
Step 2
OL-20339-01