Chapter 28
Configuring Twice NAT
Click OK.
Step 9
Configuring Identity NAT
This section describes how to configure an identity NAT rule using twice NAT. You configure identity
NAT using a static NAT rule where you map an address to itself. For more information about identity
NAT, see the
Detailed Steps
To configure identity NAT, perform the following steps:
Choose Configuration > Firewall > NAT Rules, and then click Add.
Step 1
If you want to add this rule to section 3 after the network object rules, then click the down arrow next to
Add, and choose Add NAT Rule After Network Object NAT Rules.
Figure 28-23
The Add NAT Rule dialog box appears.
OL-20339-01
"Identity NAT" section on page
Adding a NAT Rule
26-11.
Cisco ASA 5500 Series Configuration Guide using ASDM
Configuring Twice NAT
28-15