Cisco ASA 5505 Configuration Manual page 350

Feature History for Standard ACLs
In the Address field, enter the IP address of the destination to which you want to perform or deny access.
Step 6
You can also browse for the address of a network object by clicking the ellipsis at the end of the Address
field.
(Optional) In the Description field, enter a description that makes an ACE easier to understand.
Step 7
The description can contain multiple lines; however, each line can be no more than 100 characters in
length.
Step 8 Click OK.
The newly created ACE appears under the ACL.
Click Apply to save the ACE to your configuration.
Step 9
Editing an ACE in a Standard ACL
To edit an ACE in a standard ACL, perform the following steps:
Choose Configuration > Firewall > Advanced > Standard ACL.
Step 1
In the main pane, select the existing ACE that you want to edit.
Step 2
Step 3 Click Edit.
The Edit ACE dialog box appears.
Step 4 Enter the desired changes.
Click OK.
Step 5
Feature History for Standard ACLs
Table 17-2
Table 17-2 Feature History for Standard Access Lists
Feature Name
Standard ACLs
Cisco ASA 5500 Series Configuration Guide using ASDM
17-4
lists the release history for this feature.
Releases
7.0
Feature Information
Standard ACLs identify the destination IP addresses of
OSPF routes, which can be used in a route map for OSPF
redistribution.
The feature was introduced.
Chapter 17 Adding a StandardACL
OL-20339-01