Cisco ASA 5505 Configuration Manual page 432

Customizing EIGRP
Click Add or Edit to add or edit a EIGRP static neighbor.
Step 5
The Add or Edit EIGRP Neighbor Entry dialog box appears.
Choose the EIGRP AS number from the drop-down list for the EIGRP process for which the neighbor
Step 6
is being configured.
Choose the Interface Name from the Interface Name drop-down list. This chooses the interface through
Step 7
which the neighbor is available from the list.
Step 8 Enter the IP address of the neighbor in the Neighbor IP Address field.
Click OK.
Step 9
Redistributing Routes Into EIGRP
You can redistribute routes discovered by RIP and OSPF into the EIGRP routing process. You can also
redistribute static and connected routes into the EIGRP routing process. You do not need to redistribute
connected routes if they fall within the range of a network statement in the EIGRP configuration.
Note For RIP only: Before you begin this procedure, you must create a route-map to further define which
routes from the specified routing protocol are redistributed in to the RIP routing process. See
"Defining Route Maps,"
To redistribute routes into the EIGRP routing process, perform the following steps:
In the main ASDM window, choose Configuration > Device Setup > Routing > EIGRP > Setup.
Step 1
The EIGRP Setup pane is displayed.
Check the Enable EIGRP routing check box.
Step 2
In the EIGRP Process field, enter the autonomous system (AS) number for the EIGRP process. The AS
Step 3
number can range from 1 to 65535.
Choose Configuration > Device Setup > Routing > EIGRP > Redistribution.
Step 4
The Redistribution pane displays the rules for redistributing routes from other routing protocols to the
EIGRP routing process. When redistributing static and connected routes to the EIGRP routing process,
metrics are not required to be configured, although this is recommended. Each row of the Redistribution
pane table includes a route redistribution entry.
Step 5 Click Add to add a new redistribution rule. If you are editing an existing redistribution rule, go to Step 6.
The Add EIGRP Redistribution Entry dialog box appears.
Step 6 Choose the address in the table and click Edit to edit an existing EIGRP static neighbor, You can also
double-click an entry in the table to edit that entry.
The Edit EIGRP Redistribution Entry dialog box appears.
Step 7 Choose the AS number of the EIGRP routing process to which the entry applies from the drop-down list.
Step 8 In the Protocol area, click the radio button next to one of the following protocols for the routing process:
•
Cisco ASA 5500 Series Configuration Guide using ASDM
23-12
for more information about creating a route map.
Static—Redistributes static routes to the EIGRP routing process. Static routes that fall within the
scope of a network statement are automatically redistributed into EIGRP; you do not need to define
a redistribution rule for them.
Chapter 23 Configuring EIGRP
Chapter 20,
OL-20339-01