Cisco ASA 5505 Configuration Manual page 282

Defining ASDM Preferences
To allow the Packet Capture Wizard to display captured packets, enter the name of the network
h.
sniffer application or click Browse to find it in the file system.
Step 4 On the Rules Table tab, specify the following:
Display settings let you change the way rules appear in the Rules table.
a.
–
–
–
–
–
b. Deployment settings let you configure the behavior of the adaptive security appliance when
deploying changes to the Rules table.
–
Access Rule Hit Count Settings let you configure the frequency for which the hit counts are updated
c.
in the Access Rules table. Hit counts are applicable for explicit rules only. No hit count will be
displayed for implicit rules in the Access Rules table.
–
–
On the Syslog tab, specify the following:
Step 5
In the Syslog Colors area, you can customize the message display by configuring background or
•
foreground colors for messages at each severity level. The Severity column lists each severity level
by name and number. To change the background color or foreground color for messages at a
specified severity level, click the corresponding column. The Pick a Color dialog box appears. Click
one of the following tabs:
–
–
–
In the NetFlow area, to enable the display of a warning message to disable redundant syslog
•
messages, check the Warn to disable redundant syslog messages when NetFlow action is first
applied to the global service policy rule check box.
After you have specified settings on these three tabs, click OK to save your settings and close the
Step 6
Preferences dialog box.
Cisco ASA 5500 Series Configuration Guide using ASDM
9-12
Check the Auto-expand network and service object groups with specified prefix check box
to display the network and service object groups automatically expanded based on the
Auto-Expand Prefix setting.
In the Auto-Expand Prefix field, enter the prefix of the network and service object groups to
expand automatically when displayed.
Check the Show members of network and service object groups check box to display
members of network and service object groups and the group name in the Rules table. If the
check box is not checked, only the group name is displayed.
In the Limit Members To field, enter the number of network and service object groups to
display. When the object group members are displayed, then only the first n members are
displayed.
Check the Show all actions for service policy rules check box to display all actions in the
Rules table. When unchecked, a summary appears.
Check the Issue "clear xlate" command when deploying access lists check box to clear the
NAT table when deploying new access lists. This setting ensures the access lists that are
configured on the adaptive security appliance are applied to all translated addresses.
Check the Update access rule hit counts automatically check box to have the hit counts
automatically updated in the Access Rules table.
In the Update Frequency field, specify the frequency in seconds in which the hit count column
is updated in the Access Rules table. Valid values are 10 - 86400 seconds.
On the Swatches tab, choose a color from the palette, and click OK.
On the HSB tab, specify the H, S, and B settings, and click OK.
On the RGB tab, specify the Red, Green, and Blue settings, and click OK.
Chapter 9 Configuring Basic Settings
OL-20339-01