Verify The Processor Module - Oracle SPARC T5-4 Service Manual

"Remove a Processor Module or Processor Filler Module" on page 61
■
"Servicing DIMMs" on page 69
■
"Verify the Processor Module" on page 67
■

Verify the Processor Module

1. Use the Oracle ILOM fault management shell to determine if the new processor
module is shown as enabled or disabled:
start /SP/faultmgmt/shell
->
Are you sure you want to start /SP/faultmgmt/shell (y/n)?
faultmgmtsp>
If the output from the fmadm faulty command shows the replacement
a.
processor module as enabled, go to
If the output from the fmadm faulty command shows the replacement
b.
processor as disabled, go to
clear the PSH-detected fault from the server.
2. Verify that the OK LED is lit on the processor module and that the Fault LED is
not lit.
See "Processor Module LEDs" on page
Verify that the front and rear Service Required LEDs are not lit.
3.
See "Front Panel Controls and LEDs" on page 29
LEDs" on page
Perform one of the following tasks based on your verification results:
4.
If the previous steps did not clear the fault, see
■
Process" on page
■ If Step 2
processor module has been replaced successfully. No further action is
required.
If you are verifying the server after adding a second processor module,
■
return to
fmadm faulty
31.
23.
and Step 3 indicate that no faults have been detected, then the
"Server Upgrade Process" on page
y
Step 2.
"Detecting and Managing Faults" on page 23
60.
and "Rear Panel Controls and
"Diagnostics
57.
Verify the Processor Module
Servicing Processor Modules
to
67