Oracle SPARC T5-4 Service Manual page 185

2. Power off the server.
See "Removing Power From the Server" on page
3. Disconnect the power cords.
See "Disconnect Power Cords" on page 53
From the front of the server, remove the following components:
4.
Both processor modules – see
■
Module" on page
Main module – see
■
Both power supplies – see
■
Go to the rear of the server and remove the following components:
5.
All five fan modules – see
■
All PCIe carriers or PCIe filler panels – see
■
Make note of the slots for each carrier or filler panel so that you can install them into the
same slots.
Rear I/O module – see
■
You will install these components into the replacement rear chassis subassembly once you have
replaced the faulty subassembly.
"Remove a Processor Module or Processor Filler
61.
"Remove the Main Module" on page
"Remove a Power Supply" on page
"Remove a Fan Module" on page
"Remove the Rear I/O Module" on page
Remove the Rear Chassis Subassembly
51.
99.
138.
147.
"Remove a PCIe Card Carrier" on page
176.
Servicing the Rear Chassis Subassembly
158.
185