Verify The Service Processor Card - Oracle SPARC T5-4 Service Manual

Verify the Service Processor Card

target is the remote location where you stored the configuration information.
■
For example:
->
8. Verify the installation of the service processor card.
See "Verify the Service Processor Card" on page
Related Information
"Determine if the Service Processor Card Is Faulty" on page 115
■
"Remove the Service Processor Card" on page 116
■
"Verify the Service Processor Card" on page 120
■
Verify the Service Processor Card
1. Verify that the SP LED on the main module or rear I/O module is lit green.
See "Main Module LEDs" on page 98
2. Verify that the front and rear Service Required LEDs are not lit.
See "Interpreting LEDs" on page
3. Perform one of the following tasks based on your verification results:
If the previous steps did not clear the fault, see
■
If the previous steps indicate that no faults have been detected, then the service processor
■
card has been replaced successfully. No further action is required.
Related Information
"Determine if the Service Processor Card Is Faulty" on page 115
■
"Remove the Service Processor Card" on page 116
■
"Install the Service Processor Card" on page 118
■
120 SPARC T5-4 Server Service Manual • July 2016
load -source tftp://129.99.99.99/pathname
120.
or "Rear I/O Module LEDs" on page
28.
"Diagnostics Process" on page
173.
23.