Oracle SPARC T5-4 Service Manual page 83

Watch the POST output for possible fault messages. The following output indicates that
POST did not detect any faults:
->
...
0:0:0>INFO:
0:0:0>
0:0:0>POST:
0:0:0>Master set ACK for vbsc runpost command and spin...
Note -
remains at the ok prompt go to
d.
If the server remains at the ok prompt, type boot.
e. Return the virtual keyswitch to normal mode.
->
Set ???ketswitch_state' to ???normal'
f.
Switch to the system console and type the Oracle Solaris OS fmadm faulty
command.
#
If any faults are reported, refer to the diagnostics instructions described in
Faults" on page
Switch to the Oracle ILOM command shell.
5.
6.
Run the show faulty command.
show faulty
->
Target | Property
--------------------+------------------------+-------------------------------
/SP/faultmgmt/0 | fru
/SP/faultmgmt/0 | timestamp
/SP/faultmgmt/0/ | sunw-msg-id
faults/0 |
/SP/faultmgmt/0/ | uuid
faults/0 |
/SP/faultmgmt/0/ | timestamp
faults/0 |
start /HOST/console
POST Passed all devices.
Return to VBSC.
The server might boot automatically at this point. If so, go directly to
Step
set /System/keyswitch_state=normal
fmadm faulty
38.
| Value
| /SYS/PM0/CMP0/BOB0/CH1/D0
| Dec 14 22:43:59
| SUN4V-8000-DX
|
| 3aa7c854-9667-e176-efe5-e487e520
| 7a8a
| Dec 14 22:43:59
|
4d.
Verify a DIMM
Step 4e. If it
"Check for
Servicing DIMMs 83