Create Snmp User - D-Link DGS-3100 SERIES Cli Manual

DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
Command
disable snmp
authenticate trap
show snmp traps
config snmp
system_contact
config snmp
system_location
config snmp
system_name
Each command is listed in detail, as follows:

create snmp user

Purpose
Syntax
Description
Parameters
35
Parameter
<sw_contact 0-31>
<sw_location 0-31>
<sw_name 0-31>
To create a new SNMP user and add the user to an SNMP group.
create snmp user <username 24> <groupname 30> [encrypted
[by_password auth [md5 <auth_password 1-32> | sha
<auth_password 1-32>] | by_key auth [md5 <auth_key 32 or
64>| sha<auth_key 40 or 72>]]]
The create snmp user command creates a new SNMP user and
adds the user to an existing SNMP group.
<username 24> − The new SNMP username, up to 24 alphanumeric
characters.
<groupname 30> − The SNMP groupname the new SNMP user is
associated with, up to 30 alphanumeric characters.
encrypted – Allows the user to choose a type of authorization for
authentication using SNMP. The user may choose:
•
by_password – Requires the SNMP user to enter a
password for authentication and privacy. The password is
defined by specifying the auth_password below. This
method is recommended.
•
by_key – Requires the SNMP user to enter an encryption
key for authentication and privacy. The key is defined by
specifying the key in hex form below. This method is not
recommended.
auth - The user may also choose the type of authentication
algorithms used to authenticate the snmp user. The choices are:
•
md5 − Specifies that the HMAC-MD5-96 authentication level
to be used. md5 may be utilized by entering one of the
following:
•
<auth password 1-32> - A string of between 1 and 32
alphanumeric characters used to authorize the agent to
receive packets for the host.
•
<auth_key 32 or 64> - A string of exactly 32 or 64
alphanumeric characters, in hex form, to define the key used
to authorize the agent to receive packets for the host.
•
sha − Specifies that the HMAC-SHA-96 authentication level
will be used.