Managing System Files; Upgrade Firmware - Huawei Quidway S1700 Series Web User Manual

Quidway S1700 Series Ethernet Switches
Web User Manual
Title
IP
Mode
IP Address
Subnet Mask
Gateway
Address
MAC
Address
Restart
DHCP
----End

3.3 Managing System Files

Use the System > File page to manage the switch system files, including upgrading the switch
operating software or configuration files, setting the system start-up files, etc.

3.3.1 Upgrade Firmware

Use the System > File (Upgrade) page to upgrade the firmware to use for system
initialization.
To upgrade the firmware for switch:
1. Click System > File, see
2. Select Upgrade from the Action list.
3. Set the corresponding configuration parameters, and then click Apply.
SeeTable 3-3
Issue 01 (2011-11-17)
Description
Address Specifies whether IP functionality is enabled via manual configuration
(Static), Dynamic Host Configuration Protocol (DHCP). If DHCP is
enabled, IP will not function until a reply has been received from the server.
Requests will be broadcast periodically by the switch for an IP address.
DHCP responses can include the IP address, subnet mask, and default
gateway. (Default: DHCP)
Address of the VLAN to which the management station is attached. Valid IP
addresses consist of four numbers, 0 to 255, separated by periods. (Default:
192.168.0.1)
This mask identifies the host address bits used for routing to specific
subnets. (Default: 255.255.255.0)
IP IP address of the gateway router between the switch and management
stations that exist on other network segments. (Default: null)
Show the Physical address for this switch.
Click to restart DHCP service.
Figure
for the parameters of upgrade switch.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
3-4.
3 System Management
14