Oracle Solaris Os Configuration Parameters - Oracle Sun SPARC T3-2 Installation Manual

9. Log in to the server and explore its capabilities.
There are many commands you can use to verify the functionality of the system,
including:
■
■
■
Review the Oracle Solaris OS man pages and documentation for more details.
Related Information
Oracle Solaris documentation
■
SPARC T3 Series Servers Administration Guide
■
"Connect a Terminal or Emulator to the SER MGT Port" on page 51
■
Oracle Solaris OS Configuration
Parameters
When configuring the Oracle Solaris OS, you will be prompted for the following
configuration parameters. For more information about these settings, refer to the
Oracle Solaris documentation.
Parameter
Language
Locale
Terminal Type
Network?
Multiple Network Interfaces
DHCP?
Host Name
IP Address
Subnet?
showrev – Displays the host name and system architecture information. Use
the -a option with this command to see the patches that are installed.
psrinfo – Displays information about the number and status of the processors
and cores in the host.
prtdiag – Displays system configuration and diagnostic information.
Description
Select a number from the displayed languages list.
Select a number from the displayed locale list.
Select a terminal type that corresponds with your terminal device.
Select Yes.
Select the network interfaces that you plan to configure. If you are not sure,
select the first one in the list.
Select Yes or No according to your network environment.
Type the host name for the server.
Type the IP address for this Ethernet interface.
Select Yes or No according to your network environment.
Powering On the Server for the First Time 55