Table of Contents
Advertisement
boot net
boot cdrom
boot disk1:h
boot tape
boot disk myunix -as
dload <filename> ( addr -- )
Examples:
4000 dload /export/root/foo/test
?go
During the installation, supply the configuration parameters as directed.
10.
See
"Oracle Solaris OS Configuration Parameters" on page
Related Information
"Configure the Preinstalled OS" on page 63
■
"Reach a State to Install a Fresh OS (Oracle ILOM CLI)" on page 63
■
"Reach a State to Install a Fresh OS (Oracle ILOM Web Interface)" on page 65
■
"Assign a Static IP Address to the NET MGT Port" on page 68
■
Oracle Solaris OS Configuration Parameters
When configuring the Oracle Solaris OS, you are prompted for the following configuration
parameters. For more information about these settings, refer to the Oracle Solaris
documentation.
Parameter
Language
Locale
Terminal Type
Network?
Multiple Network Interfaces
DHCP?
Host Name
IP Address
Subnet?
Subnet Netmask
from DISK if present, otherwise from NET.
- boot kernel from network
- boot kernel from CD-ROM
- boot from disk1 partition h
- boot default file from tape
- boot myunix from disk with flags "-as"
debug load of file over network at address
- if executable program, execute it
or if Forth program, compile it
Description
Select a number from the displayed language list.
Select a number from the displayed locale list.
Select a terminal type that corresponds with your terminal device.
Select Yes.
Select the network interfaces that you plan to configure. If you are not sure, select the first one in the
list.
Select Yes or No according to your network environment.
Type the host name for the server.
Type the IP address for this Ethernet interface.
Select Yes or No according to your network environment.
If your answer to Subnet? was Yes, type the netmask for the subnet for your network environment.
Reach a State to Install a Fresh OS (Oracle ILOM Web Interface)
67.
Powering On the Server for the First Time
67
Advertisement
Table of Contents
