Replacing The Diskette Drive Cable Assembly; Figure 8-4 Removing And Replacing The Diskette Drive Cable Assembly - Sun Microsystems Ultra 2 series Service Manual

FIGURE 8-4
8.2.4

Replacing the Diskette Drive Cable Assembly

Caution –
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing it on any surface.
1. Replace the diskette drive cable assembly as follows (
a. Position the diskette drive cable.
b. Connect the following:
P1 connector to J1201 on the motherboard.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
J1201
Removing and Replacing the Diskette Drive Cable Assembly
Use proper ESD grounding techniques when handling components. Wear
P2
Diskette drive
cable assembly
P1
):
FIGURE 8-4
Chapter 8 Major Subassemblies 8-9