Replacing The Video Board; Memory Card; Removing The Memory Card; Figure 10-9 Removing /Replacing The Video Board - Sun Microsystems SPARCstation Voyager Service Manual

Screw
Pins
Removing /Replacing the Video Board
FIGURE 10-9

Replacing the Video Board

1. Position the new video board on the three pins.
See . The video board connector should stick out of the slot on the system
FIGURE 10-9
unit.
2. Insert and tighten the three screws.
3. Connect the flex cable to the video board.
See .
FIGURE 10-8
4. Gently press the speaker tabs and insert the speaker back into its cavity.
See .
FIGURE 10-7
5. Close the system and power it on.

Memory Card

Removing the Memory Card

1. Pull the pull tab out from behind the defective memory card.
Screws
Chapter 10 System Boards and Component Replacement
Connector
Video board
103