Back Panel Pinhole Switches - Oracle Sun Server X4-4 Service Manual

Ethernet Port Boot Order
The order in which the BIOS detects the Ethernet ports during server boot is listed below.
1. NET 0
2. NET 1
3. NET 2
4. NET 3
You can change the boot priority using the Boot Device Priority screen available in the
Note -
Boot menu of the BIOS Setup Utility.
Ethernet Port Device Naming
Naming used by the interfaces might vary from that listed below, depending on which
Note -
devices are installed in the system.
The device naming for the Ethernet interfaces is reported differently by different interfaces
and operating systems. The following illustration explains the logical (operating system) and
physical (BIOS) naming conventions used for each interface. These naming conventions might
vary depending on conventions of your operating system and which devices are installed in the
server.
Port BIOS
Net 3 8101
Net 2 8100
Net 1 0701
Net 0 0700

Back Panel Pinhole Switches

This section shows the location of the back panel pinhole switches.
Assign Serial Port Output Using the Web Interface
Solaris Linux
igb 3 eth 3
igb 2 eth 2
igb 1 eth 1
igb 0 eth 0
Troubleshooting and Diagnostics
Windows
net 4
net3
net2
net
61