Preparing To Service The Server; Prepare The Server For Hot Service - Oracle Sun Server X4-4 Service Manual

Preparing to Service the Server

This section includes preliminary and preparatory information and procedures for servicing the
server. The following table describes the contents of this section.
Description
Procedural information for preparing to
perform hot service on the server.
Procedural information for preparing to
perform cold service on the server.
Procedural information for releasing the
Cable Management Arm (CMA)
Procedural information for server power-off
options.
Procedural information for using the Locator
indicator.
Procedural information for the server cover.

Prepare the Server for Hot Service

Note -
performed using the Oracle ILOM CLI interface. For more information, refer to the Oracle
ILOM documentation.
A hot-service component can be serviced while the server is operating at full-power mode. For
more information about component serviceability, see
This procedure describes how to prepare the server to remove, replace, or install the following
hot-service components:
Storage drives
■
Fan modules
■
Power supplies
■
Important: Review the server Product Notes document before performing removal and
■
Before You Begin
installation procedures.
This procedure uses the Oracle ILOM web interface. However, the procedure can be
Links
"Prepare the Server for Hot Service" on page 89
"Prepare the Server for Cold Service" on page 90
"Release the CMA" on page 94
"Powering Off the server" on page 97
"Managing the Locator Indicator" on page 104
"Remove the Server Cover" on page 107
"Component Serviceability" on page
Preparing to Service the Server
66.
89