Install a Memory Riser Card
4.
Ensure that the levers have risen completely and have locked the DIMM in the
slot.
5.
Repeat the above steps until all replacement DIMMs are installed.
Caution -
of the memory riser (MR) card. All populated and unpopulated DIMM slot ejector levers on the
MR card must be in the fully-closed position before installing the card in the server. Ensure that
all levers are closed and locked.
"Install a Memory Riser Card" on page 138
Next Steps
■
Install a Memory Riser Card
When servicing the components in this section, unplug the AC power cords and use ESD
protection.
Use this procedure to install a memory riser (MR) card into its slot.
For serviceability considerations, see
■
Before You Begin
For DIMM designation information, see
■
For reference information, see
■
138
Sun Server X4-4 Service Manual • October 2015
Component damage. Open DIMM ejector levers can break off during the installation
"Memory Riser Card and DIMM Reference" on page
"Component Serviceability" on page
"Component Designations" on page
66.
69.
141.