D Setting The Gps Alarm - Icom ID-51A Advanced Manual

Previous view
10
GPS OPERATION
■ GPS memory operation (Continued)

D Setting the GPS alarm

A GPS alarm can sound when a target position comes
into the alarm area.
This function can be set to the caller station, all GPS
Memory channels, a specified Memory group or a
specified Memory channel.
• Alarm area (Group) — Setting plural stations
When all channels or group is selected:
Point A
0.25'
Your
position
Point B
Point C (
q Push [MENU] .
w Push D-pad() to select the root item ("GPS"), and
then push D-pad(Ent).
D-pad
(Ent)
( )
e Push D-pad() to select "GPS Alarm," and then
push D-pad(Ent).
r Push D-pad( ) to select "Alarm Select," and then

push D-pad(Ent).
t Push D-pad( ) to select "Group," and then push D-

pad(Ent).
y Push D-pad( ) to select "All Memories," and then

push D-pad(Ent).
• If you wish to set the alarm to a GPS Memory group,
select one between A to Z or "(No Group)."
u Push [MENU] to exit the Menu screen.
• When either one of the stations in a specified group en-
ters its set range, the beep sounds three times.
• When the GPS alarm beeps, "GPS ALARM" pops up on
the screen and then the "S" icon blinks.
• To cancel the GPS alarm, repeat step t and select
"OFF."
NOTE: When "Group" is selected in step t, and a tar-
get position enters in the active alarm range specified
in "Alarm area (Group)" of the Menu screen, the GPS
alarm sounds. (p. 16-39)
(MENU > GPS > GPS Set > Alarm Area (Group))
• GPS Alarm beeping screen
Blinks
N
0.25'
)
Beeps three times
The pop up is
displayed and
beeps 3 times.
• Alarm area (RX/Memory)— Setting specific stations
When a specified memory is selected:
Your
position
Beeps one times
Example: Alarm Area (Group)
Alarm Setting is set to all GPS Memories.
10-21
Extended range
(approx. 1 km; 1094 Y)
Limited range
(approx. 500 m; 547 Y)
Beeps three times
"All Memories"
is displayed.