D Memory Bank Scan - Icom ID-51A Advanced Manual

Previous view
13
SCAN OPERATION
■ Memory scan (Continued)

D Memory bank scan

A memory bank scan searches through the memory
channels in the selected bank.
• Two or more memory channels, which are not set as skip chan-
nels, must be programmed to start a memory bank scan.
• When the "BANK" item in the MENU screen is set to "OFF,"
a bank scan is not started.
q Push [M/CALL] one or more times to select the
Memory mode.
w Push [QUICK] to open the Quick Menu screen.
e Push D-pad() to select "Bank Select," and then
push D-pad(Ent).
D-pad
(Ent)
( )
r Rotate [DIAL] to select a desired bank group to be
scanned, and then push D-pad(Ent).
• Only Bank groups that have memory channels assigned
to them are displayed.
t Hold down [MODE]
y Push D-pad ( ) to select the scan type.

• ALL : Full bank scan
• BANK-LINK : Bank link scan
• BANK-A to Z : Bank scan
( Only banks which contain a memory chan-
nel are displayed.)
• DUP : Duplex scan (p. 13-2)
( Appears only when duplex is set on the
channel.)
• TONE : Tone scan (For tone scanning)
u Push D-pad(Ent) to start the scan.
i To cancel the scan, hold down [SCAN]
• Pushing [CLR] also cancels the scan.
TIP: Holding down [SCAN]
also selects the scan type. The scan immediately
starts when [SCAN]
NOTE:
• The bank contains only channels which are set as
"SKIP" or "PSKIP" are skipped.
• When the all selected banks contain only channels
which are set as "SKIP" or "PSKIP," the scan is not
started.
for 1 second.
for 1 second.
[DIAL]
and rotate [DIAL]
is released.
When a signal is received.
The S-meter shows the
received signal strength.
13-10
Push [M/CALL]
Hold down [SCAN]
for 1 second.
Push D-pad() to
select, then push
D-pad(Ent).
Blinks
Blinks
Blinks
Bank channel
number
Blinks
.