Scan Stop Beep - Icom ID-51A Advanced Manual

Previous view
16
MENU SCREEN
■ Sounds items (Continued)
Band Edge Beep
Sounds > Band Edge Beep
Turn the Band edge beep ON or OFF.
• OFF: Band edge beep is OFF.
• ON: When you tune into or out of the AIR, VHF and UHF band's frequency
range with [DIAL], a beep sounds.

Scan Stop Beep

Sounds > Scan Stop Beep
Turn the scan stop beep ON or OFF.
• OFF: No beep sounds.
• ON: A beep sounds when a received signal stops the scan.
Standby Beep
Sounds > Standby Beep
Turn the standby beep function ON or OFF.
This function sounds a beep after a received signal disappears.
• OFF:
• ON:
• ON (to me: High Tone):
• ON (to me: Alarm/High Tone): Turns ON the function to sound a beep.
TIP:
• The standby beep sounds even when "OFF" is selected in Key-touch beep.
• The standby beep output level follows the Beep level setting.
16-90
(Default: ON (to me:Alarm/High Tone))
Turns OFF the function.
Turns ON the function to sound a beep.
Turns ON the function to sound a beep.
When a received signal addressed to your
call sign disappears, a high pitched beep
sounds. When any other received signal
disappears, a regular beep sounds.
When a received signal addressed to
your call sign disappears, an alarm sound
(PiRoPiRoPiRo) sounds.
- If you release [PTT] and/or a signal is re-
ceived within 5 seconds, the alarm sound
changes to a high pitch beep sound when
the received signal disappears.
- If no signal is received for 5 seconds af-
ter you release PTT, the next signal ad-
dressed to your call sign will again sound
the alarm sound. When any other received
signal disappears, a regular beep sounds.
(Default: OFF)
(Default: OFF)