Icom ID-51A Advanced Manual page 260

Previous view
16
MENU SCREEN
■ Menu items and Default settings (Continued)
NOTE: The default settings shown below are for the USA version.
The default settings may differ, depending on your transceiver version.
Voice Memo In this item, set the TX/RX voice recording options.
QSO Recorder <<REC Start>>*
Play Files*
Recorder Set
Player Set
Voice Recorder Record*
Play Files*
Recorder Set
Player Set
DV Auto Reply*
*
Be sure to insert the microSD card into the transceiver before selecting these items.
In this item, set the microphone voice recording options.
Voice TX
Record*
TX Set Repeat Time
TX Monitor
<<Single TX>>*
<<Repeat TX>>*
*
Be sure to insert the microSD card into the transceiver before selecting these items.
RANGE OR VALUE (Default is shown in bold)
PLAY FILES
TX&RX or RX Only
REC Mode
RX REC Condition Always or Squelch Auto
OFF or ON
File Split
OFF or ON
PTT Auto REC
3sec, 5sec, 10sec or 30sec
Skip Time
PLAY FILES
1, 2, 3 or 4
MIC Gain
3sec, 5sec, 10sec or 30sec
Skip Time
RANGE OR VALUE (Default is shown in bold)
1sec~5sec~15sec
OFF or ON
16-5
DESCRIPTIONS
Starts recording the received signal audio.
Plays or deletes the recorded audio.
Selects to record the TX audio or not.
Selects whether or not the squelch status
affects the RX voice audio recording.
Selects whether or not to automatically
create a new file if transmission and re-
ception, or squelch status (open and
close) is switched.
Turns the PTT Automatic Recording func-
tion ON or OFF.
Sets the Skip time to rewind or forward the
recorded audio when you push the fast-re-
wind or fast-forward key during playback.
Starts recording the microphone audio.
Plays or deletes the recorded audio.
Sets the microphone sensitivity to suit
your needs.
Sets the Skip time to rewind or forward the
recorded audio when you push the fast-re-
wind or fast-forward key during playback.
Records a voice audio to use the Auto
Reply function in the DV mode.
DESCRIPTIONS
Starts recording the microphone audio.
Sets the repeat interval. The transceiver
repeatedly transmits the recorded voice
audio at this interval.
The TX Monitor function outputs the TX
voice audio from the speaker during voice
transmission.
The transceiver transmits the recorded
voice audio only one time.
The transceiver repeatedly transmits the
recorded voice audio for a maximum of
10 minutes.