Icom ID-51A Advanced Manual page 165

Previous view
10
GPS OPERATION
■ GPS memory operation
D Setting the GPS alarm (Continued)
q Push [MENU] .
w Push D-pad() to select the root item ("GPS"), and
then push D-pad(Ent).
D-pad
(Ent)
( )
e Push D-pad() to select "GPS Alarm," and then
push D-pad(Ent).
r Push D-pad( ) to select "Alarm Select," and then

push D-pad(Ent).
t Push D-pad( ) to select "RX," and then push D-

pad(Ent).
• If you want to set the alarm to a specified GPS memory
channel, select "Memory," then push D-pad(Ent). And
then, select the channel in the GPS memory group.
y Push [MENU] to exit the Menu screen.
• When a set station is in the approximate 1 kilometer
range, GPS Alarm beeps once, and when it is in the ap-
proximate 500 meter range, beeps three times.
(Default: Both)
• When the GPS alarm beeps, "GPS ALARM" pops up on
the screen and then the "S" icon blinks.
• To cancel the GPS alarm, repeat step t and select
"OFF."
NOTE:
• When "RX" or a GPS memory channel is selected
, the GPS alarm sounds depend on the "Alarm
step t
Area (RX/Memory)" setting in the Menu screen.
(p. 16-40)
(MENU > GPS > GPS Set > Alarm Area (RX/Memory))
• Even if "RX" is selected
signal has no position, the GPS alarm does not
sound.
, and the received
in step t
Example: Alarm Area (RX/Memory)
Alarm Setting is set to RX.
in
• GPS Alarm beeping screen
10-22
"RX" is
displayed.
Blinks
The pop up is displayed
and beeps sound, de-
pending on the setting
of the alarm area.